Fake Gagged Holly Willoughby

ELF ( FARAMIR)

I keep beating around the time of preparing a leather bracelets and there are many models one does not know where to start, unless you have it clear. Since I saw those who had Faramir Ranger when dressed in the Lord of the Rings I knew that these would be elected, my favorite. So I decided to work and got the material I would need: Leather
two different qualities, a kind fine morocco and another drive.
Cutter, punch and some tools to work the tin that serve to mark and emboss.
leather glue. Thick needle and thread colors. Scissors and paper patterns, is ls designs easy to find online, wooden block base to the punch, silver pen.



STARTED

Step 1: began to mark and cut the pattern on the basis of the finest leather.




This is the template that I got from internet which is the main drawing further highlighted in the leather.




Step 2: now cut the hardest piece of leather that go on top and that will carry the drawing.




Step 3: will set the template and begin to make the design on the leather for tracing. After drawing embossed with calm and patience, making a fine cut into the leather, dipping a little piece for the local humidity let us work and pushing or pulling the skin.





Step 4: this process is long and quite tiring, especially if it is the first time you venture into something like this, the following will stick a piece on the other and to get the "stuck" is not flat, it will go on curved forearms. We work on a cylindrical piece to make it curve, anything with it that way, I used a bottle.




Step 5: when it is dry proceed to sew the two pieces to decorate the thread well serve as a reinforcement. Leather sewing cost much especially if it is dual layer, so we will facilitate the operation to help us with a punch and make holes at the same distance as if we were the sewing machine.



need strength, a thimble to push or a wooden board to help raise the needle. We will stitching on the upper part profile with orange thread. For this is just fine embroidery thread.




From here tomáoslo easy because you will end with your fingers sore, itchy and almost squeezing, throwing and DJing. Once the triangular piece you can continue decorating the sides of the bottom strips with another color (green in my case) to give more joy to the whole.
eventually fills the stars and the white tree with silver paint (I used a pen Stabilo metallic silver 950).

Here is the result:







And the picture below is for you can compare my result with the original Faramir, has not been too bad .. eh?
I can only buy the two buckles, cosérselas to each strip and make holes to finally be able to. As soon as you go up the photo.



buckles I've got to complete the job. Here you can see it.









I hope you enjoyed it and encourage you to make your own bracelets.
And before I show the photo finish of the day sewing leather breastplate of the vest white tree end takes the ornament on the neck and sides (although this photo is not) has hooks leather washers gold to close the overalls with a lanyard.

Sewing the leather breastplate to the vest.

The end result:

Ana Leonor Hernandez.